This is an old revision of the document!
Input | Type | Description |
---|---|---|
Power | Digital | Bringing this pin high will toggle the power of the chiller. |
Mode | Digital | Bringing this pin high will toggle the operating mode of the chiller (heat/cool). |
Output | Type | Description |
Unit ID | 8-bit analogue | |
Mode of Oper | Analogue (8-bit) | |
Stages Avail | Analogue (8-bit) | |
Bypassed Stages | Analogue (8-bit) | |
Stages On/Off | Analogue (8-bit) | |
Return Temp Stage 1 | Analogue (8-bit) | |
Supply Temp Stage 1 | Analogue (8-bit) | |
Stage 1 Supply Temp | Analogue (8-bit) | |
Stage 2 Supply Temp | Analogue (8-bit) | |
Stage 3 Supply Temp | Analogue (8-bit) | |
Stage 4 Supply Temp | Analogue (8-bit) | |
Stage 5 Supply Temp | Analogue (8-bit) | |
Stage 6 Supply Temp | Analogue (8-bit) | |
Stages Not Responding | Analogue (8-bit) | |
Stages Locked Out | Analogue (8-bit) | |
Stage 1 Fault | Analogue (8-bit) | |
Stage 2 Fault | Analogue (8-bit) | |
Stage 3 Fault | Analogue (8-bit) | |
Stage 4 Fault | Analogue (8-bit) | |
Stage 5 Fault | Analogue (8-bit) | |
Stage 6 Fault | Analogue (8-bit) |
A standard modem cable (male connector on one end, female on the other, no crossed wires) should be used.