343QDCM - Quad DC Input Module


Quad DC Input Module, software configurable to monitor 0 - 10 V, 0 - 50 V, -5 - +5 V, or -25 - +25 V.


Frequently asked questions

Why does bootloading fail when updating from V2.01 revB to V2.02 revB2?

Firmware written for revB hardware will not run on revB2 hardware (and vice versa). If you have attempted to perform this update, it should be possible to power-cycle the device, then reload the old firmware. More information on recovering from a failed update can be found on the updating module firmware page (requires distributor login). If you are unable to recover the device using these procedures, it must be returned to E-Plex for repair.

hardwarepub/modules/343qdcm.txt · Last modified: 2016/02/22 11:23 by Bob Lynas
Recent changes RSS feed

Wiki help | Staff area